Removing And Installing Memory; Removing Memory; Installing Memory - Matrox 4Sight-II Installation And Hardware Reference

Removing and installing memory

The Matrox 4Sight-II motherboard features one 168-pin DIMM slot. This slot
can support SDRAM modules up to 1 Gbyte in size. This section describes how
to remove and install an SDRAM module. Matrox 4Sight-II supports 3.3 V,
unbuffered, PC/100-compliant SDRAM DIMMs.

Removing memory

To remove memory:
1. Spread the clips at each end of the module.
2. Lift the module out of the slot.

Installing memory

To install memory:
1. Ensure that the clips at each end of the module are spread.
2. Position the module over the DIMM slot, such that the notches along the module's
bottom edge align with the notches in the DIMM slot.
3. Gently insert the bottom edge of the module into the slot.
4. Carefully close the clips over the side notches.
SDRAM module
clip
notches
DIMM slot
Removing and installing memory 55