Table of Contents
Advertisement
Enabling or disabling
a boot device
Main
QuickBoot Mode:
SETUP prompt
POST Errors:
Max boot failure: [Enabled]
Summary screen:
Floppy check:
AC/Power Loss:
Boot Order:
Indicates disabled device
(press
F1
Help
Esc
Exit
It is also possible to enable or disable a boot device using the Boot menu. By
default, all connected devices are enabled. To disable them, select the device using
the Up and Down keys and press Shift+1. You will notice the "!" character appear
to the left of the selected device. Press Shift+1 to enable the device again. The "!"
character will disappear.
Matrox 4Sight-II Setup Utility
Advanced
Power
Boot
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Stay Off]
!
Removable Devices
-Hard Drive
!
ATAPI CD-ROM Drive
I.B.A. Slot 0058
Shift+1
to enable).
#$
Select Item
Select Menu
fg
If you cannot enable a device (that is, if the "!" character will not disappear), check
to see if the device is connected properly, or even present on your unit.
Sometimes, a device's name might still appear in the Boot menu, even if it is not
connected to your unit. Because the BIOS does not detect it, the device is tagged
as disabled (!), and you cannot enable it.
You might, however, want to remove the unconnected device's name from the
Boot menu:
1. Select the name of the disconnected device that appears in the Boot menu.
2. Press d.
The device's name will be removed.
Info
Exit
Bootable Add-in Cards
Primary Master
Secondary Master
-/+
Change Values
Enter
Select
Sub-Menu
Item Specific Help
F9
Setup Defaults
F10
Save and Exit
Boot menu
131
Advertisement
Table of Contents
