Matrox 4Sight-II Installation And Hardware Reference page 166

166 Appendix C: Technical reference
Caution
Base Configuration
Pin Signal
9 CLOCK, INPUT, X+
10 DATA, INPUT, X2+
11 DATA, INPUT, X1+
12 DATA, INPUT, X0+
13 INNER SHIELD
Medium Configuration
Pin Signal
1 INNER SHIELD
2 DATA, INPUT, Z3+
3 CLOCK, INPUT Z+
4 DATA, INPUT, Z2+
5 DATA, INPUT, Z1+
6 DATA, INPUT, Z0+
7 TERMINATED
8 DATA, INPUT, Y3+
9 CLOCK, INPUT , Y+
10 DATA, INPUT, Y2+
11 DATA, INPUT, Y1+
12 DATA, INPUT, Y0+
13 INNER SHIELD
Use the Camera Link cable from your camera manufacturer or from 3M
Interconnect Solutions for Factory Automation, to interface with the above
connectors. Note that this cable is not available from Matrox.
Manufacturer:
Camera Link cable Part Number:
If using the two Camera Link connectors, the cables you choose should be of the
same type and length.
Pin Signal
22 CLOCK, INPUT, X -
23 DATA, INPUT, X2-
24 DATA, INPUT, X1-
25 DATA, INPUT, X0-
26 INNER SHIELD
Pin Signal
14 INNER SHIELD
15 DATA, INPUT, Z3-
16 CLOCK, INPUT Z-
17 DATA, INPUT, Z2-
18 DATA, INPUT, Z1-
19 DATA, INPUT, Z0-
Ω
20
100
21 DATA, INPUT, Y3-
22 CLOCK, INPUT , Y-
23 DATA, INPUT, Y2-
24 DATA, INPUT, Y1-
25 DATA, INPUT, Y0-
26 INNER SHIELD
3M Interconnect Solutions for Factory Automation
14X26-SZLB-XXX-0LC