Adjusting Your New Memory Settings; Connecting Devices To The Auxiliary I/O Interface - Matrox 4Sight-II Installation And Hardware Reference

56 Chapter 3: Adding devices to the Matrox 4Sight-II motherboard
Connecting LVTTL
devices

Adjusting your new memory settings

If the Matrox Imaging Library (MIL) or one of its derivatives is installed in your
unit, you must adjust your unit's new memory settings using the MIL
Configuration utility. Please refer to the software manual for more information
on using this utility.
Connecting devices to the auxiliary I/O
interface
If you have purchased the motherboard-only version of Matrox 4Sight-II, you will
have to connect devices to the internal auxiliary I/O interface connector, located
on the motherboard.
Internal auxiliary
I/O connector
To connect low-voltage TTL (LVTTL) devices to the internal auxiliary I/O
connector, you will need a custom cable with a 26-pin, IDC, female connector.
Pinout information for the internal auxiliary I/O connector can be found in
Technical reference. You can also refer to this appendix, for information on where
the custom cable connector can be obtained.
Back Panel
TM
PC/104- Plus
expansion site
DIMM slot