Connecting A Pc/104-Plus Board; Some Considerations - Matrox 4Sight-II Installation And Hardware Reference

Connecting a PC/104-Plus board

You can connect up to three PC/104-Plus boards on the
Matrox 4Sight-II motherboard in a stack-through configuration, as shown below.
Each board must be attached to the other through four jack screws.

Some considerations

The following points are critical when connecting additional PC/104-Plus boards
to the Matrox 4Sight-II motherboard:
• The voltage I/O pins on the Matrox 4Sight-II PC/104-Plus connector are set to
3.3 V.
• If you are connecting a standard PC/104 board, it must be the top module, since
it does not include the PCI bus.
• Matrox 4Sight-II does not support PC/104 ISA boards that require -12 V.
• The PC/104-Plus board might have a PCI shroud, a plastic case that protects the
PCI connector pins. However, it hinders air circulation, and therefore should be
removed before installation.
Plus
PC/104-
module 3
Plus
PC/104-
module 2
Plus
PC/104-
module 1
Matrox 4Sight-II motherboard
Plus
PC/104-
(PCI) connector
Connecting a PC/104-Plus board
Top-most board fitted
with top-screws
board
Fit jack-screws inside
appropriate holes.
board
Connect jack-screws
together.
board
PC/104
(ISA) connector
53