Table of Contents
Advertisement
102 Appendix A: Troubleshooting
➘
Memory has been added but the change is not registered by your unit.
• Ensure that your RAM is compatible with Matrox 4Sight-II and that it has been
properly installed.
• If you have previously installed MIL or Matrox Inspector on your hard drive, you
can use the MIL Configuration utility to handle the amount of DMA (physically
contiguous, non-pageable) memory on your unit. Alternatively, you can uninstall
your Matrox software before adding memory and reinstall the software after the
memory has been added. One of these procedures is necessary due to the fact that
these Matrox software packages reserve DMA memory for grabbing.
Advertisement
Table of Contents
