Matrox 4Sight-II Installation And Hardware Reference page 37

Connecting to Y/C
input signals
Connecting to RGB
input signals
Connecting to other
signals
You can interface up to six Y/C cameras to Matrox Orion /Standard or /RGB for
4Sight-II, whereas you can interface up to 12 Y/C cameras to Matrox Orion /Dual
for 4Sight-II. In addition to the DBHD44-TO-13BNC cable, you will also need
the BNC-TO-SVHS adapter cables.
The procedure to connect each Y/C camera is as follows:
1. Using the BNC-to-SVHS adapter cable, attach the SVHS connector to your Y/C
camera.
2. Attach the two female BNC connectors on the adapter cable to the appropriate
male BNC wires on the DBHD44-TO-13BNC cable, using the wire information
in the previous table.
3. Attach the DBHD44 connector to the video input connector of Matrox 4Sight-II.
(Use "Video in" for the /Dual module.)
4. For the /Dual module only: repeat steps 1 to 3 for the wires of the second cable,
and attach the DBHD44 connector to the "Video in 2" connector of Matrox
4Sight-II.
You can interface up to two RGB cameras to Matrox Orion /RGB for 4Sight-II.
To do so:
1. Connect the BNC wires to each RGB camera using the information in the previous
table.
2. Attach the DBHD44 connector to the "Video in" connector of Matrox 4Sight-II.
You can also use a DBHD44-TO-13BNC/O cable if you need to interface other
signals (such as special user input and output signals) in addition to composite,
Y/C, and RGB video signals. The DBHD44-TO-13BNC/O cable is an
open-ended version of the DH44-TO-13BNC cable. The pinout of the video
input connector, found in Technical reference, contains a list of all the signals
available along the interface. After referring to this table, you can then refer to the
color code pinout chart, included with your cable, to connect the appropriate wire.
Connecting video input devices 37