Connecting A High-Resolution Analog Display Device - Matrox 4Sight X Installation And Hardware Reference

34 Chapter 2: Connecting peripherals to the unit

Connecting a high-resolution analog display device

To connect a high-resolution analog display device to the analog video output
connector on the Matrox 4Sight X unit, do the following:
1. If your device has a standard HD-15 connector, use a standard HD-15 to HD-15
cable, and skip the remaining steps. Note that sometimes a HD-15 connector is
referred to as a DB-15 connector.
2. If your device has 5 BNC-type connectors, use a standard HD-15 to 5-BNC cable.
These cables are usually supplied with your device. To connect your device with
a HD-15 to 5-BNC, refer to steps 3 and 4.
3. If your device has input impedance switches, set the switches for the red, green,
and blue inputs to 75 ohms, as shown in the following illustration.
( B N C )
R
B
75 75 75
( B N C )
( B N C )
RED BLUE GREEN
G HSYNC
VSYNC
75
INT
EXT
( B N C ) ( B N C )
WHITE BLACK
or
GRAY