Table of Contents
Advertisement
28
Running DigiUtils Setup
Chapter 3: Installing the DigiSuite Software
Connect your VTR for device control
If you'll be installing the VTR driver that lets you control your VTR with
DigiTools, you should connect your VTR to your computer as explained
in the section "Setting up for device control" in Chapter 2 of your Getting
the Most from DigiSuite manual. DigiUtils Setup will prompt you for the
COM port to which you've connected your VTR.
Once the software installation is complete, you'll need to configure your
VTR settings using the DigiSuite Configuration program as explained in
the next chapter (see
The following instructions will guide you through the DigiUtils
installation process. DigiUtils Setup will prompt you to choose a
directory in which to install the DigiUtils files and a location for the
program icons. Certain messages appear throughout the process to
inform you of installation progress or errors.
Note
The default directory for the DigiUtils files is
C:\DigiSoft\DigiUtil. If you want to install to a different directory and
plan on accessing it with MS-DOS, don't use a directory name longer
than eight characters.
If, at any point, you choose to exit DigiUtils Setup, a dialog box will
appear offering you a choice of resuming the installation process or
exiting. If you choose to exit, the software will not be correctly installed.
Thus, you will have to run Setup again before attempting to run any of
the programs.
Some of the DigiUtils Setup dialog boxes feature
These allow you to move in either direction through the installation. If
you wish to change an installation choice in a previous dialog box, move
back; when you've finished, go on to the next step.
Step-by-step installation instructions
1. Close Control Panel and all Windows programs (except for Program
Manager in NT 3.51).
2. Insert the DigiSuite CD-ROM in your CD-ROM drive.
3. NT 4.0:
Choose
NT 3.51:
In Windows NT Program Manager, choose
4. In the resulting dialog box, type e:\digiutils\setup (where e:
represents your CD-ROM drive), and click
"Configuring your VTR settings" on page
.
Start | Run
49).
Back
and
Next
buttons.
.
File | Run
.
OK
Advertisement
Table of Contents
