Other Problems - Matrox 4Sight-II Installation And Hardware Reference

➘
The colors are wrong.
Incorrect colors indicate that either the cabling (for monitors that do not have a
built-in cable) or the monitor impedance is incorrect.
• Make sure your monitor's input impedance switches (if any) are set to 75 ohms
for the red, green, and blue inputs.
• Check that your monitor cable is properly connected.
➘
The display is not centered.
• Adjust the centering control of your monitor (refer to your monitor's manual for
more information).
➘
The picture quality is poor, with a dim picture, poor contrast, and poor
sharpness.
• Adjust the brightness, sharpness, and contrast controls of your monitor (refer to
your monitor's manual for more information).
• Check that your monitor cable is properly connected.
• Make sure your monitor's input impedance switches (if any) are set to 75 ohms
for the red, green, and blue inputs.
➘
The picture is broken up, with bad horizontal sync; in other words, it rolls,
jitters, or blinks.
• Set the synchronization switches to high impedance and external sync mode. If
this does not solve the problem, your monitor might need horizontal setting
adjustments, or it might be defective. Refer to your monitor's manual.
• Ensure that the resolution you specified is valid for your monitor.

Other problems

➘
Mismatched network settings resulting in very slow communication.
• Determine the server setting and configure Matrox 4Sight-II to match these
networks settings.
Common problems and solutions 101