Printer specifications and requirements
Space requirements
6-6
Table 6-6. Environmental specifications for 96/4635/180 printers
Condition
Heat dissipation:
96 and 4635
(2-stacker system)
180
(2-stacker system)
Audible noise:
You should consider the following factors when deciding where to
place the printing system hardware components:
•
Adequate work space and service clearance around the
equipment
•
Proximity to electrical and network connectors
•
Security of the work area. You may need to place the system
in an area where you can restrict access to it. This may be
important if your personnel need to print confidential
documents or if you are concerned with unauthorized usage.
Dimensions and weights of the printer components are listed in
this section, along with diagrams, to help you visualize the sizes
and total space requirements.
NOTE: There must be a 78-inch / 198-cm vertical clearance
throughout the entire area. Your printer must be installed in a
fixed location with a minimum clearance space of 36 inches /
91.4 cm around all sides of each piece of equipment for access
by service personnel. In addition, there must be 50 inches /
126.9 cm clearance space in front of the printer.
Range
Operating:
28,140 BTU/hour
Standby:
4,454 BTU/hour
Energy Saver:
2,700 BTU/hour
Operating:
32,770 BTU/hour
Standby:
4,454 BTU/hour
Energy Saver:
2,700 BTU/hour
Operating:
Continuous:
82 dB(A)
Impulse:
82 dB(A)
Standby:
Continuous:
52 dB(A)
Impulse:
N/A
Installation Planning Guide
Need help?
Do you have a question about the DocuPrint 100 and is the answer not in the manual?