Defining The Printer To The Host: Tcp/Ip Attachment; Mvs Or Os/390 Parameters; Software Prerequisites - Mvs - Xerox DocuPrint 100 Installation Planning Manual

Xerox docuprint 100: install guide
Hide thumbs Also See for DocuPrint 100:
Table of Contents

Advertisement

MVS or OS/390 parameters

Software prerequisites – MVS
Installation Planning Guide
F.
Defining the printer to the host:
TCP/IP attachment
This appendix contains instructions, prerequisites, and some
sample printer parameters for defining your TCP/IP-attached
printer to your host, in each PSF environment.
This section discusses the parameters and procedures required
to define a printer to your host, followed by examples of the
parameters required for a Token Ring connection using TCP/IP
in a MVS environment.
NOTE: The MVS examples shown are for a Token Ring
connection. However, the same parameters will be required for
an Ethernet connection using TCP/IP.
On an MVS/ESA or OS/390 host system, you must have the
following software to print through PSF on a TCP/IP-attached
printer:
PSF/MVS Version 3, release 2.0, with APAR OW 15599 or
later
MVS Scheduler APAR OW 12236 to support two new
PRINTDEV keywords: IPADDR and PORTNO
TCP/IP Version 3, release 1 or higher, installed and
configured on MVS.
You must have these prerequisites installed on your host before
you begin the configuration process described in this chapter.
Ensure that the manuals for the proper software releases are
used.
F-1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DocuPrint 100 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents