Other Supplies; Dry Ink - Xerox DocuPrint 100 Installation Planning Manual

Supplies

Other supplies

Dry ink

MICR dry ink
A-12
This section describes the supplies other than paper that are
necessary for installation and afterward. Your sales
representative will help you place your initial supply order.
Dry ink (also called toner) is the black powder which forms the
image on the printed page. There are three cartridges of dry ink
in each carton. You should keep at least one extra cartridge on
hand at all times. The disposable cartridges are easily changed
with no mess. The consumption rate of Xerox dry ink is
approximately one cartridge per 60,000 pages. Use only dry ink
that is specified for use in the 96, 4635, or 180 printer, as
described in the consumable supplies table.
MICR dry ink is the magnetic black powder which forms the
image on the printed MICR document. There are three
cartridges of MICR dry ink in each carton. The consumption rate
of Xerox MICR dry ink is approximately one cartridge per 60,000
pages. Use only MICR dry ink in your 96/4635/180 MICR printer.
The dry ink used with the 96/4635/180 MICR system is designed
for MICR printing and does not function well when used in non-
MICR systems. The same procedure used for non-MICR printing
systems is used to add the dry ink to the 96/4635/180 MICR
printer.
NOTE: Dry ink (toner) yields are based on 7% area coverage.
Your yield may vary, depending on coverage.
Installation Planning Guide