Download  Print this page

Configuration Steps - As/400 - Xerox DocuPrint 100 Installation Planning Manual

Xerox docuprint 100: install guide
Hide thumbs

Advertisement

Defining the printer to the host: TCP/IP attachment
Configuration steps – AS/400
Configuration
worksheet
Table F-14. AS/400 configuration worksheet for NPS/IPS
Item description
Also known as...
Device
DEVD
description
Remote location
RMTLOCNAME
Port number
PORT
PSF
PSFCFG
configuration
F-22
NOTE: There may be printer performance and throughput
implications with some of these configurations. It is
recommended that your network management group be involved
with planning this installation.
Follow these steps to configure your AS/400 to print to a printer
connected to the LAN, using TCP/IP.
The following worksheet will help you in planning the printer
installation. It describes the key values which you need to supply
when planning the AS/400 configuration. All values on this
worksheet must be determined before you begin the printer
configuration on the host.
Source
This is the name of the printer (writer). An
Output Queue of the same name is
automatically created. Spool files that you
place in this Output Queue are directed to the
printer.
Xerox printer software installation. This is the
printer IP address.
Use the Set Option command to set the
option IPDSTcpPortNumber. The value 5001
works best for IPDS printers.
Same as Device description
NOTE: It is assumed that your AS/400 is connected to the LAN
and all the prerequisite software is installed and configured.
1. Configure the printer for TCP/IP at the printer controller
Refer to the Guide to Configuring and Managing the System for
the procedure to specify the TCP/IP option.
Your value
Installation Planning Guide

Advertisement

Table of Contents
loading

  Related Manuals for Xerox DocuPrint 100