Installing the Printer
Installing the
Printer
Before You Begin
Space Requirements
Top View
1
60.5 inches (1540 mm)
2
36 inches (920 mm)
3
4 inches (100 mm)
4
12 inches (305 mm)
5
36.5 inches (925 mm)
6
72 inches (1830 mm)
1-14
DP N24, N32 and N40 System Administrator Guide
This section describes the procedures for unpacking and setting up
the printer in its base configuration. If you have additional options
to install, refer to Appendix C: Installing and Removing Printer
Options for specific instructions for each option.
Be sure to read this entire section before continuing on to the
installation steps. This section contains important information
concerning your safety and the safety of the printer.
For easy operation, maintenance and replacing of consumables, you
should select a location for the printer that leaves the minimum
clearances around the printer as shown in Figure 1.4 for a base
configuration, and in Figure 1.5 on page 1-15 when options are
installed.
Figure 1.4
Space requirements for a base configuration