Download  Print this page

Xerox DocuPrint 100 Installation Planning Manual page 202

Xerox docuprint 100: install guide
Hide thumbs

Advertisement

Defining the printer to the host: TCP/IP attachment
Table F-5. PSF/MVS PRINTDEV statement parameters (Continued)
Item
description
Default
SETUP
No Setup
message
s issued
RELINTV
RELMODE
None
TIMEOUT
TRACE
NO
F-12
Range of
Source of
acceptable
value
values
Installation
SETUP=FORMS
preferences
if specified
IDLE, TIME, or
NONE
Installation
REDRIVE or
preferences
STOP
YES or NO
NOTE: To specify a TCP/IP address space name other than
the default (TCPIP), code the following EXEC statement in
the appropriate PSF writer procedure:
STEP01 EXEC PGM=APSPPIEP,
PARM=(,,,,tcpip_name), REGION=4096K
where tcpip_name is the name of the TCP/IP address space.
Comments
If specified, causes JES
to issue FORMS setup
message when a job
prints which has a
FORMS specification
different from job
previously printed. This is
recommended where
there are multiple paper
stocks for use on the
printer.
Not applicable to Xerox
cut-sheet printers
Not applicable to Xerox
cut-sheet printers
REDRIVE: When there is
a time-out after period
specified in DISCINTV
parameter, REDRIVE
requests that PSF
attempt to drive the
printer according to
MGMTMODE
specification.
STOP: Forces operator
to restart FSA.
Note: REDRIVE is
recommended for TCP/IP
printers that may be
shared with other hosts.
Should be used only for
debugging PSF-related
problems.
Installation Planning Guide
Your
value

Advertisement

Table of Contents
loading

  Related Manuals for Xerox DocuPrint 100