Xerox DocuPrint 100 Installation Planning Manual page 83

Table 5-3. DocuPrint NPS/IPS printer controller specifications and power requirements:
Dimensions (depth,
Device width, height)
Processor d=25 in. / 63.5 cm
w=10 in. / 25.4 cm
h=17.75 in. / 45.1 cm
Monitor d=10 in. / 25.4 cm
w=17.5 in. / 44.5 cm
h=18.5 in. / 47 cm
4 mm d=12.25 in. / 31 cm
cartridge
w=7.5 in. / 19 cm
tape drive
h=2.75 in. / 7 cm
Keyboard d=7.5 in. / 19.1 cm
w=20 in. / 50.8 cm
Mouse d=3 in. / 8 cm
w=4 in. / 10 cm
h=2 in. / 5 cm
Channel d=9.7 in. / 24.6 cm
interface
w=27.1 in. / 68.8 cm
board and
channel
cable
connector
box (channel
attached
systems
only)
Installation Planning Guide
For a summary of printer hardware specifications and
requirements, refer to the "Printer specifications and
requirements" chapter of this guide. Contact your service
representative if you have questions not specifically addressed in
this guide.
Sun Blade 1000
Heat
Weight dissipation Power requirements
70 lbs. / 1,100 BTU
31.8 kgs per hour
18 lbs. / 408 BTU
8.2 kg per hour
8 lbs. / ---
6.6 kg
2 lbs. / ---
1kg
0.3 lbs. / ---
0.14 kg
--- ---
60 Hz:
100 to 240 VAC,
15 amp, 0.4 KVA,
5-15 NEMA
50 Hz:
100 to 240 VAC,
15 amp, 0.4 KVA
100-120 ~ VAC,
1 phase, 50-60 Hz,
3.0 amp, 0.4 KVA
200-240 ~ VAC,
1 phase, 50-60 Hz,
2.0 amp, 0.4 KVA
100-120/200-240 VAC,
0.8/0.4 amp, 47-63 Hz
---
---
100 to 240 VAC,
15 amp, 0.4 KVA
Cable lengths
Power: 8 ft. /
2.4 m
Interface to
printer:
20 ft. / 6.1 m
usable length
Video cable to
processor:
46 in. / 1.17 m
SCSI cable to
processor or
additional SCSI
device:
28 in. / 71 cm
72 in. / 1.8 m
25 in. / 63 cm
Bus and tag
cables must
conform to host
system
requirements
(200 gray cable
to 400 ft. blue
cable / 66.7 to
133.3 m) and
accommodate
system setup.
Cable from board
to box: 3 ft / 91.5
cm
5-9