Table of Contents
Advertisement
SERVICING YOUR OUTBOARD MOTOR
6. Install the oil drain bolt cover. Push
the lever of the oil drain bolt cover
in the direction pointed by the
arrow mark of ''LOCK'', and
install the oil drain bolt cover so
that the locking lug securely sets on
the projection of the under cover.
7. With the outboard motor in a
vertical position, fill to the upper
limit mark on the dipstick (p. 63)
with the recommended oil.
Engine oil refill capacity:
Without oil filter change:
6.9 US qt (6.5 L)
With oil filter change:
7.1 US qt (6.7 L)
8. Install the oil filler cap and tighten
it securely.
9. Install and lock the engine cover.
66
Oil Filter Change
1. Drain the engine oil, and then
reinstall the drain bolt and sealing
washer. Reinstall the drain bolt
cover (see Engine Oil Change on
p. 64).
2. Tilt the outboard motor, and place a
suitable container below the oil
drain guide to catch the used oil.
3. Use a suitable tool to remove the
oil filter, and thoroughly drain the
filter into the used oil container.
FILTER WRENCH, 65 mm
OIL FILTER
OIL DRAIN GUIDE
RUBBER SEAL
Advertisement
Table of Contents
