Replacement Of Oil Filter - TOHATSU MFS25 Service Manual

6) Replacement of Oil Filter

1. Drain engine oil.
2. Place a piece of rag below oil filter area, and remove it by
using oil filter wrench 1.
• Replace oil filter 5 minutes or more after
stopping engine.
• Wipe off spilt oil completely.
Oil Filter Wrench 1 :
P/N. 3AC-99090-0
3. Apply thin coat of engine oil to O ring of filter before installing
filter. Clean the cylinder at the location where the oil filter is
installed.
4. Install oil filter and tighten it to specified torque by using oil
filter wrench 1.
Oil Filter :
18 N·m ( 13 lb·ft ) [1.8 kgf·m]
Pour engine oil from oil inlet 2.
5.
Recommended Engine Oil :
4 Stroke Engine Oil
4st
API : SE, SF, SG, SH, SJ, SL
SAE : 10W-30, 10W-40
NMMA : FC-W Certified 10W-30
Quantity of Engine Oil :
When oil filter is replaced: 1.8L
When oil filter is not replaced: 1.6L
Attach oil filler cap 3 and oil level gauge 4, start and run
6.
engine for 5 minutes to warm up.
7. Stop engine and check oil level and oil leak after 5 minutes.
25/30 2006
1
1
4st
4st OIL
1
2
3
5 Oil Level Gauge 6 Upper Limit (MAX) 7 Lower Limit (MIN)
3
4
5
6
7
3-7