Propeller Installation - TOHATSU MD 40B2 Owner's Manual

32
INSTALLATION
Do not disconnect the battery leads from
battery while the engine is operating, the
electrical parts could be damaged.
Always use a fully charged battery.
ENOW00015-0
Do not use a batter y that is not recom-
mended. Use of a battery not recommended
can lead to poor performance of, and/or
damage to, the electrical system.
ENON00006-A
Note
5
Recommended battery: 12V 100Ah/5HR,
850 (Cold Cranking Amps (CCA), In case of
cold whether: 12V120Ah/5HR (1000CCA))
Specifications and features of batteries
vary among the manufacturers. Consult
the manufacturer for details.
* The battery should be purchased sepa-
rately and is not supplied with the out-
board motor.
1. Place the battery box in a convenient
position away from possible water
spray. Securely fasten both the box
and the battery so they do not shake
loose.
2. Connect the positive lead (+) to the
positive terminal (+) of the battery,
and then connect the negative lead
(—). When disconnecting the battery
always remove the negative lead (—)
first. After connecting the positive
terminal (+), securely place a cap on
it to prevent short circuits.
CAUTION
1
1. Battery cord (red)
2. Battery cord (black)
ENOM00123-0

4. Propeller installation

ENOW00085-A
WARNING
Do not begin propeller removal and installa-
t i o n p r o c e dur e w i t h s p a r k p lu g c a p s
attached, shift in forward or reverse, main
switch at other than "OFF", engine stop
switch lock attached to the switch, and
starter key attached, or engine could acci-
dentally start leading to serious personal
injury.
Disconnect battery cable if possible.
2
ENOF00022-0