Installation Of Propeller Shaft Housing - TOHATSU MFS 4D Service Manual

Lower Unit
Install pump case (upper) ass'y 8 on the gear case, and
5.
tighten bolts 9 in two or three steps to specified torque.
Apply grease to interior of pump case liner, and
install pump case (upper) by pushing it down
with hand while turning drive shaft clockwise.
Pump Case (Upper) Bolts 9 :
6 N · m (4 lb · ft) [0.6 kgf · m]
OBM
OBM OBM
Bring grommet 0 protrusion d to hole e, and install it to
6.
pump case (upper) ass'y 8.
4st OIL
4st
OBM
OBM OBM

31) Installation of Propeller Shaft Housing

Ass'y
1. Check that OBM grease is applied to lip of oil seal of
propeller shaft housing ass'y 1.
Install propeller shaft ass'y 2 to propeller shaft housing
2.
ass'y 1.
Apply grease to new O-ring 3 and install it.
3.
Apply grease to clutch push rod 4 and install it to propeller
4.
shaft ass'y 2.
Attach propeller shaft housing ass'y 1 to gear case, and
5.
tighten bolts 6 to specified torque.
Propeller Shaft Housing Bolts 6 :
6 N · m (4 lb · ft) [0.6 kgf · m]
OBM
OBM OBM
· Apply grease to clutch push rod to prevent it
from dropping when attaching.
· When installing propeller shaft housing ass'y
to gear case, tighten upper and lower bolts in
2 or 3 steps evenly to specified torque.
6-26
9
OBM OBM d
OBM
9
e
OBM OBM
OBM
1
OBM OBM
OBM
3
4
OBM OBM
OBM
8
0
4st
4st OIL
8
6
OBM OBM
OBM
2
6
4st 4/5/6 2020