Cell Explanations - Thermo Scientific SmartView SV100A User Manual

Point Programming Forms
Cell Abnormal Value: This numeric value is used as base point data by certain
point types (equations, conditionals) in the event that the base point is in
Explanations
an abnormal state (invalid, TCBO, overrange, etc.).
Auto, Reset: Assign as on or off; if on, assign time/day for daily, weekly, or
monthly
Base Point: Assign a point as the base point.
Colors: Assign the normal and alarm colors for a point.
Compensation: Assign local or remote compensation for thermocouple
points.
Contact Output Number, Alarm: Assign each of the alarm set points to
one of the optional contact outputs; enter 0 for no contact output
assignment.
Currents: Enable or disable (Yes or No) current source for measuring
resistance.
Deadband, Alarm: Applies to alarm set points (Hi or Lo); difference
between the value of when the point goes into alarm and the value of when
the alarm is cleared.
Deadband, Reset: Enter the allowable deadband around the target
temperature for sterilization.
Decimal: Enter a decimal fix of 0 to E (Exponential); separates the integer
part of the number from the fractional part (Dec. Fix = 2; 100.75).
Degree: Select degrees Fahrenheit or Celsius.
Delay, Alarm: Assign the delay time before an alarm activates.
Display Grid: Assign the number of major and minor grids to be displayed.
Display Scale: Assign the low and high scale ends on the display.
Equation: Enter an equation formula for this point.
Event, Reset: Assign an event number to reset a point (reset type points
only).
Filter: Enter the number of filter seconds.
Flow Rate: Assign a flow rate units of /sec, /min, /hour, or /day for totalize
points.
Gate: Assign a gate (yes or no).
Input Scale, High End: Enter high end of input voltage range.
Input Scale, Low End: Enter low end of final engineering units output.
Thermo Fisher Scientific SV100/SV10C User Guide C-17