Thermo Scientific SmartView SV100A User Manual page 91

Thermo Fisher Scientific
2. Display Scale screen:
Figure 5–35. Equation Calculated type point programming: Display Scale screen
(linear scale)
a. Tag: You can assign a tag with up to 20 characters to each
programmed point.
b. Units: An alphanumeric engineering units message with a
maximum of 20 characters may be assigned for voltage and current
inputs.
c. Normal and Alarm Colors: You can set the normal pen trace,
bargraph, or digital block color. Additionally, you can set pen trace
or bargraph to display a different color if the point goes into alarm.
Press the Normal or Alarm color box and select the desired color.
d. Display block: Refer to the Similar Programming Parameters
section for instructions. Note the following difference:
Scale Type: If you select a Linear scale (shown in Figure 5–35),
then refer to Similar Programming Parameters to set the grids,
high/low scales, bands, and decimal fix parameters. If you select a
Log scale (shown in Figure 5–36), then grids are not programmable
because they are fixed based on the number of log scale decades.
Program high/low scales and bands as described in Similar
Programming Parameters. Decimal Fix is also not programmable,
as log points are displayed as base 10 exponentials.
e. Press Next.
Point Programming
Programming
SV100A/SV10AC User Guide 5-33