Table of Contents
Advertisement
Thermo Fisher Scientific
3. Refer to Figure 2–4. With the recorder held firmly in place against the
relay rack, install one of the jackscrews by inserting the jackscrew nut
into the keyhole located on the top of the instrument.
4. Use a screwdriver to screw the jackscrew leadscrew in until the
jackscrew holds the relay rack against the front of the instrument bezel.
Do not tighten the leadscrew completely at this time.
5. Install and tighten the remaining jackscrew into the keyhole located on
the opposite side of the instrument.
6. Use a screwdriver to tighten both jackscrew leadscrews until the relay
rack is held securely against the instrument bezel. Recommended
torque is 30 ±3 lb./in.
Figure 2-5. Multiple recorders in relay rack
Installation & Wiring
Installation
SV100A/SV10AC User Guide
2-7
Advertisement
Table of Contents
Troubleshooting
