Thermo Scientific SmartView SV100A User Manual page 174

Point Programming Forms
C-18 SV100/SV10C User Guide
Interval, Reset: Enter the time, weekday, or day of month for a reset
interval.
Last Base Point: Assign a point as the last base point in a series.
Low Flow Cutoff: Assign a low value to stop totalization.
Offset: Assign thermocouple offset correction value.
Output Scale, High End: Enter high end scale value or exponential value
for Log calculation.
Output Scale, Low End: Enter low end scale value or exponential value for
Log calculation.
Period, Time: Assign the time length of the moving window, Gated Timer
Period
Point #: Enter desired number (01 through 36).
Point, Compensation: Assign remote compensation point number.
Rate, Alarm: Enter rate of change value in engineering units (based on per
minute change).
Reference Temperature: Enter the reference temperature for sterilization.
Save on Reset: Yes or No.
Set Point, Alarm: Enter the alarm set point values that relate to areas within
the range of the chart scale values.
Set Point, Alarm: Assign a set point for an alarm.
Span: Assign thermocouple span correction value.
Start, Reset: Enter the start time in hours and minutes.
Tag, Point: Enter 10-character (maximum) descriptive phrase identifying
each point.
Target Temperature, Reset: Enter the target temperature for sterilization.
Time Period: Assign a time period in seconds for Moving Average type
points.
Time-out: Enter the time period programmed between signal updates
before flagging the point invalid.
Type, Alarm: Assign the alarm type of None, High, Low, Rate, Abnormal,
Open, or Closed.
Type, Point: Define the type of signal input to be measured (J/TC, RTD,
4–20 mA, etc.) or math calculation to be performed (Addition, Square
Root, etc.).
Thermo Fisher Scientific