Thermo Scientific SmartView SV100A User Manual page 104

Screen Types
Horizontal & Vertical Trend Screens
6-6 SV100A/SV10AC User Guide
 Interval Trigger:
Figure 6–9. Interval trigger setup
Sync Time – Allows you to synchronize the times that actual
sample data are stored.
Normal Rate – Specifies the frequency at which the recorder
stores data from all points within the designated point group.
Alarm Rate – Specifies the frequency at which the recorder
stores data from points when they go into alarm.
Example: Entering 00:15:00 as the Sync Time, 00:15:00 as the
Normal Rate, and 00:05:00 as the Alarm Rate results in the
results in the recorder beginning to take samples at 15 minutes
after the hour (Sync Time) in intervals of 15 minutes (Normal
Time) and to record data from points in alarm for 5 minutes
(Alarm Rate).
 Alarm Trigger: Selecting the Alarm trigger type opens the Stop
Mode section. In Figure 6–10, the recorder collects data until
the alarm clears. In Figure 6–11, the recorder collects 100
samples from points in alarm.
Figure 6–10. Stop Mode – Alarms Clear
Thermo Fisher Scientific