Table of Contents
Advertisement
JOG operation example
Example 1
When the "stop signal" is turned ON during JOG operation, the JOG operation will stop by the "deceleration stop" method.
If the JOG start signal is turned ON while the stop signal is ON, the error "Stop signal ON at start" (error code: 1908H) will
occur.
The inching operation can be re-started when the stop signal is turned OFF and the JOG start signal is turned ON from OFF.
■Operation example
[Cd.190] PLC READY
OFF
signal
OFF
[Cd.191] All axis servo
ON signal
OFF
READY signal
([Md.140] Module status: b0)
OFF
[Cd.181] Forward run
JOG start
OFF
[Cd.180] Axis stop
OFF
[Md.141] BUSY signal
ON
ON
ON
ON
ON
ON
Ignores that the JOG start signal is turned
ON from OFF while the stop signal is ON.
5 MANUAL CONTROL
5.2 JOG Operation
5
159
Advertisement
Table of Contents
Troubleshooting
