Mitsubishi Electric MELSEC iQ-FX5 User Manual page 129

Setting positioning data
When using the JUMP instruction, set the following positioning data.
: Always set, : Set as required, : Setting not required
Setting item
[Da.1] Operation pattern
[Da.2] Control method
[Da.3] Acceleration time No.
[Da.4] Deceleration time No.
[Da.6] Positioning address/movement amount
[Da.7] Arc address
[Da.8] Command speed
[Da.9] Dwell time/JUMP destination positioning data No.
[Da.10] M code/Condition data No./Number of LOOP to LEND repetitions
[Da.20] Axis to be interpolated No.1
[Da.21] Axis to be interpolated No.2
[Da.22] Axis to be interpolated No.3
Refer to the following for information on the setting details.
Page 416 Positioning Data
Setting required/not required


(Set the JUMP instruction.)






(Set the positioning data No.1 to 600 for the JUMP destination.)

(Set the JUMP instruction execution conditions with the condition data
No.
0: Unconditional JUMP
1 to 10: Condition data No. ("Simultaneous start" condition data cannot
be set.))



3 MAJOR POSITIONING CONTROL
3.2 Setting the Positioning Data
3
127