[Cd.31] Simultaneous starting axis start data No.1
• Use this data item to specify a start data No.1 for each axis that starts simultaneously.
Fetch cycle: At start
■Setting value
Refer to "[Cd.30] Simultaneous starting own axis start data No.".
Page 488 [Cd.30] Simultaneous starting own axis start data No.
• Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 366 Axis control data
[Cd.32] Simultaneous starting axis start data No.2
• Use this data item to specify a start data No.2 for each axis that starts simultaneously.
For 2 axis simultaneous starting, the axis setting is not required. (Setting value is ignored.)
Fetch cycle: At start
■Setting value
Refer to "[Cd.30] Simultaneous starting own axis start data No.".
Page 488 [Cd.30] Simultaneous starting own axis start data No.
• Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 366 Axis control data
[Cd.33] Simultaneous starting axis start data No.3
• Use this data item to specify a start data No.3 for each axis that starts simultaneously.
For 2 axis simultaneous starting and 3 axis simultaneous starting, the axis setting is not required. (Setting
value is ignored.)
Fetch cycle: At start
■Setting value
Refer to "[Cd.30] Simultaneous starting own axis start data No.".
Page 488 [Cd.30] Simultaneous starting own axis start data No.
• Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 366 Axis control data
10 DATA USED FOR POSITIONING CONTROL
10.8 Control Data
10
489