Creating A Program; General Configuration Of Program - Mitsubishi Electric MELSEC iQ-FX5 User Manual

11.2

Creating a Program

The "positioning control operation program" actually used is explained in this section.

General configuration of program

The general configuration of the positioning control operation program is shown below.
No. Program name
1 Parameter setting program
2 Positioning data setting program
3 Block start data setting program
4 Servo parameter setting program
5 Home position return request OFF program
6 External command function valid setting program
7 PLC READY signal ON program
8 All axis servo ON program
9 Positioning start No. setting program
10 Positioning start program
11 M code OFF program
12 JOG operation setting program
13 Inching operation setting program
14 JOG operation/inching operation execution program
15 Manual pulse generator operation program
16 Speed change program
17 Override program
18 Acceleration/deceleration time change program
19 Torque change program
20 Step operation program
21 Skip program
22 Teaching program
23 Continuous operation interrupt program
24 Target position change program
25 Restart program
26 Parameter initialization program
27 Flash ROM write program
28 Error reset program
29 Axis stop program
Remark
• The program is not required when the parameter, positioning data, block
start data, and servo parameter are set using an engineering tool.
• The setting of the home position return parameters is not required when
the machine home position return control is not executed.
Not required when the fast home position return is executed.


Not required when the M code output function is not used.
Not required when the JOG operation is not used.
Not required when the inching operation is not used.
Not required when the JOG operation or the inching operation is not used.
Not required when the manual pulse generator operation is not used.
Add the program as necessary.

11 PROGRAMMING
523
11.2 Creating a Program
11