Mitsubishi Electric MELSEC iQ-FX5 User Manual page 275

Teaching procedure
The following shows the procedure for a teaching operation.
• When teaching to the "[Da.6] Positioning address/movement amount" (Teaching example on axis 1)
Start
Perform machine home position
return on axis 1.
Move the workpiece to the target
position using a manual operation.
Set "Writes the feed current value
to "[Da.6] Positioning address/
movement amount"" in teaching
data selection.
Set the positioning data No.
for which the teaching will be
carried out.
Confirm completion of the teaching.
NO
End teaching?
YES
Turn OFF the "[Cd.190] PLC
READY signal".
Carry out a writing request to the
flash ROM.
Confirm the completion of the writing.
End
Using a JOG operation, inching operation, or manual pulse generator operation.
Set 0 in "[Cd.38] Teaching data selection".
Set the positioning data No. in "[Cd.39] Teaching positioning data No.".
Confirm that "[Cd.39] Teaching positioning data No." has become 0.
Set 1 in "[Cd.1] Flash ROM write request".
Confirm that "[Cd.1] Flash ROM write request" has become 0.
7 CONTROL SUB FUNCTIONS
7.9 Other Functions
7
273