Mitsubishi Electric MELSEC iQ-FX5 User Manual page 321

[Pr.800] Mark detection signal setting
Set the input signal for mark detection.
Setting value
0
1 to 4
1 to 8
If a value other than the above is set, the warning "Outside mark detection signal setting range" (warning code: 0936H) occurs
and the target mark detection is not available.
Set "4: High speed input request" in "[Pr.42] External command function selection" and set "1: Validates an external
command." in "[Cd.8] External command valid".
[Pr.801] Mark detection signal compensation time
Compensate the input timing of the mark detection signal.
Set this parameter to compensate such as delay of sensor input. (Set a positive value to compensate for a delay.)
[Pr.802] Mark detection data type
Set the data that latched at mark detection.
The target data is latched by setting "0 to 14". Set the axis No. in "[Pr.803] Mark detection data axis No.".
Optional 2 word buffer memory is latched by setting "-1". Set the buffer memory No. in "[Pr.804] Mark detection data buffer
memory No.".
Setting value
0
1
2
3
6
7
8
9
10
11
12
13
14
-1
If a value other than the above is set, the warning "Outside mark detection data type setting range" (warning code: 0937H)
occurs and the target mark detection is not available.
Setting details
Invalid
External command signal (DI) of axis 1 to axis 4 (4-axis module)
External command signal (DI) of axis 1 to axis 8 (8-axis module)
Data name
Feed current value
Machine feed value
Real current value
Servo input axis current value
Synchronous encoder axis current value
Synchronous encoder axis current value per cycle
Current value after composite main shaft gear
Current value per cycle after main shaft gear
Current value per cycle after auxiliary shaft gear
Cam axis current value per cycle
Cam axis current value per cycle (Real position)
Feed current value of command generation axis
Current value per cycle of command generation axis
Optional 2 words buffer memory
8 COMMON FUNCTIONS
8.9 Mark Detection Function
8
319