Table of Contents
Advertisement
Figure 5-9. Solenoid Mounting Bracket with Connector and Spare Air Line
4. Cut and discard the cable ties holding the spare air line at the top of the mounting
bracket. Move the air line away to facilitate the mounting of the solenoid
manifold (see
Figure
5. Mount the solenoid manifold onto the bracket using the supplied M3 x 25 mm
screws and washers (see
6. Insert the spare air line into the air intake coupling of the solenoid manifold.
Make sure the air line is pushed in all the way and secured in place by the intake
coupling. Confirm by pulling on the air line.
NOTE: If you are installing a Solenoid Kit on a Cleanroom or IP-65 robot,
the spare air line is used for a different purpose in those robots. You will
have to provide a piece of 6 mm tubing to run from one of the 6 mm user
airlines at the Joint 2 cover to the air intake coupling mentioned above.
7. Plug the connector plug into the female connector jack (marked SOLND) on the
bracket.
8. Use cable ties, as needed, to secure the air line to the bracket.
Adept Cobra i600/i800 Robot User's Guide, Rev E
5-9).
Figure 5-10 on page
Installing the Robot Solenoid Kit
Spare air line
Connector for the
solenoid valves
Pem nuts to mount the
solenoid manifold
68).
67
Advertisement
Table of Contents
