Table of Contents
Advertisement
Chapter 10 - IP-65 Option
User Air Lines
On the back of the Joint 1 cover, the user air line connectors are fitted with removable
plugs at the factory - see
The user air line connectors on the outer link are accessible with the cover removed. See
Figure 10-13 on page 139
When routing air lines outside of the robot, any fittings you use must maintain an
adequate seal in the cover to prevent moisture from entering the outer link.
Robot Solenoid Option
In an IP-65 robot, if you are installing the internally-mounted solenoid hand valves
(Adept Option Kit P/N 02853-000), you must use a different air line than described in
Section 5.6 on page
The internal air line normally used to supply the solenoid manifold is instead used to
provide positive airflow pressure to the bellows/outer link. You can use one of the
passive 6 mm user air lines shown in
140
Adept Cobra i600/i800 Robot User's Guide, Rev E
Figure 10-12 on page
for locations of the internal connectors.
CAUTION:
Failure to prevent water intrusion through
improperly sealed external fittings will void your
warranty.
65.
Figure 10-12
139.
and
Figure 10-13 on page
139.
Advertisement
Table of Contents
