Table of Contents
Advertisement
Chapter 2 - Safety
2.5
Intended Use of the Robots
The installation and use of Adept products must comply with all safety instructions and
warnings in this manual. Installation and use must also comply with all applicable local
and national requirements and safety standards (see
The Adept Cobra i600 and i800 robots are intended for use in parts assembly and material
handling for payloads less than 5.5 kg (12.1 lb).
The Adept Cobra i-series robots are component subassemblies of a complete industrial
automation system. The standard Adept Cobra i-series robots must not come into contact
with liquids.
The Adept equipment is not intended for use in any of the following situations:
• In hazardous (explosive) atmospheres
• In mobile, portable, marine, or aircraft systems
• In life-support systems
• In residential installations
• In situations where the Adept equipment will be subject to extremes of heat or
humidity. See
ranges.
Non-intended use of an Adept Cobra i-series robot can:
• Cause injury to personnel
• Damage the robot or other equipment
• Reduce system reliability and performance
All persons that install, commission, operate, or maintain the robot must:
• Have the necessary qualifications
• Read and follow exactly the instructions in this User's Guide
If there is any doubt concerning the application, ask Adept to determine if it is an
intended use or not.
28
Adept Cobra i600/i800 Robot User's Guide, Rev E
WARNING:
For safety reasons, it is prohibited to make
certain modifications to Adept robots (see
Table 3-1 on page 37
WARNING:
The instructions for installation, operation,
and maintenance given in this User's Guide must be
strictly observed.
Section 2.8 on page
Section
for allowable temperature and humidity
30).
2.6).
Advertisement
Table of Contents
