Clear; Run/Stop; Single; Auto - Rigol DS7000 Series Quick Manual

RIGOL

CLEAR

RUN/STOP

SINGLE

AUTO

14
Press this key to clear all the waveforms on the screen. If
the oscilloscope is in the "RUN" state (the key is
illuminated in yellow), new waveforms will still be
displayed.
Press this key to set the state of the oscilloscope to
"RUN" or "STOP".
In the "RUN" state, the key is illuminated in yellow.
In the "STOP" state, the key is illuminated in red.
Press this key to set the trigger mode to "Single", the key
is illuminated in orange. In single trigger mode, press
FORCEto generate a trigger signal immediately.
Press this key to enable the waveform auto setting
function. The oscilloscope will automatically adjust the
vertical scale, horizontal time base and trigger mode
according to the input signal to realize optimum
waveform display.
frequency of the signal under test should be no lower
than 25Hz. If the parameter exceed the limit, "Can't
detect any signal!"willbe displayed after pressing this key
and the quick parameter measurement menu might not
be displayed.
Note: auto setting requires that the
MSO2000A/DS2000A Quick Guide