Removing A Fluid Line - Waters TRIZAIC UPLC System Manual

Removing a fluid line

Required materials
• Chemical-resistant, powder-free gloves
• Sharp cutting tool
To remove a fluid line:
Warning:
with biohazardous and/or toxic materials. Always wear
chemical-resistant, powder-free gloves while performing this
procedure.
Warning:
performed on its source before commencing this procedure.
1. Prepare the instrument for working on its source (see
Warning:
take great care while working with these components.
2. Pull open the source enclosure door, and then locate the fluid line
connector plate.
Fluid line connector plate location:
3. Backward trace the fluid line you want to replace, and then disconnect it
from the port on the nanoACQUITY UPLC instrument, or from the
grounded union connected to the reference valve on the mass
spectrometer, in accordance with the supplied documentation.
See also:
The probe and source components can be contaminated
To avoid electric shock, prepare the instrument for work
The probe and source can be hot. To avoid burn injuries,
nanoACQUITY UPLC System Operator's Guide.
page 2-1).
Connector plate
Safety and handling 3-5