Setup - Test Operation X/Y - Roland R4000 Manual

B0059001 / Rev. 2.3
7.13 Setup – Test operation X/Y
Fig. 44: Setup the test operation
The function "X/Y" serves for checking and optimizing the program parameter settings (on signal
type "eddy current").
In this mode the signal is shown two-dimensionally. At the signal type "Y Component" only the
vertical signal share is considered.
X-share of signal:
Y- share of signal:
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Weld Seam Detection System R4000 SND40
for Tubes, Cans and Drums
yellow line.
green line.
Manual
Operation
81