Roland R4000 Manual page 162

Technical records
11.2.4.3 Retro-fitting the cable driver module
Fig. 88: Retro-fitting the cable driver module
• Loosen all cable plugs and the 4 fixing screws.
Every screw connection consists of an M3 screw, a toothed washer and a flat washer.
• Do not lose any parts, danger of short-circuit.
• Note: Older units are equipped with a flat plug at the lower right screw joint.
Do not forget this when mounting the driver module.
• Replace every screw by one of the provided spacer bolt.
• Plug-on the cable driver module.
Take care that every connector at the module gets into the corresponding contact on the
eddy current module.
• Fasten the module with the remaining screws.
• For older units: re-attach the flat plug for the shielding connection.
• Re-plug all cables onto the cable driver module.
Pos: 127 /Schweis snah t/Gerä te/SN D40/1 1 Tech nis che Un terla gen/Hinwei se zu Hard-u nd Sof tware @ 0\mod_1 1483 960 963 75_5 01.do cx @ 21 63 @ 2 2 @ 1
162
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Weld Seam Detection System R4000 SND40
for Tubes, Cans and Drums
Manual
B0059001 / Rev. 2.3
Retrofit
Cable driver
1:
module