Table of Contents
Advertisement
B0059001 / Rev. 2.3
Method 2: Calibration without PC connection, but with a external USB keyboard
•
Connect a USB keyboard.
•
Terminate SND40 program (ESC key).
•
The procedure in calibration without PC is almost identical.
No Telnet connection is required. So proceed with the calibration as described
in method 1.
•
Instead of a USB keyboard you may also use a USB mouse.
•
Finally, when you return to the start screen make the taskbar visible.
•
Press "Run" and execute "cmd.exe".
•
Enter: ndcucfg
•
Type the following commands and confirm each by pressing „Enter"::
reg save
quit
The changes are now saved.
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Weld Seam Detection System R4000 SND40
for Tubes, Cans and Drums
Manual
Start application SND40_10
3:
Scroll until you find "SND40_10"
and restart the application.
Maintenance
141
Advertisement
Table of Contents
