Table of Contents
Advertisement
Technical records
Minimal wiring of interface
Operation condition: Setup – Edit (X/Y)
Condition!
1.
The unit must be in "Setup - Edit" condition.
2.
System parameter "Test job control mode: KM" (by SND40 key)
3.
X/Y operation (started / terminated by key operation).
4.
The PLC must already have the tube prepared for rotation. The PLC must then accordingly output the signal "motor"
to rotate the tube.
Parallel Data Outputs
OUT2 / Ready for measuring
OUT5 / General fault
OUT7 / Motor
t1:
< 100 ms
t2:
The user will end the X/Y operation with the <Stop> key.
t3:
< System parameter "time"
t4:
≥ 0 ms
The total duration of the X/Y operation will be determined via key operation by the user.
1)
Not mentioned inputs / outputs of the interface are not required for parameter programming.
146
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Weld Seam Detection System R4000 SND40
for Tubes, Cans and Drums
Key / Start
Key / Stop
1)
Manual
t1
t2
t3
B0059001 / Rev. 2.3
t4
Advertisement
Table of Contents
