Setup X/Y Diagnosis - Roland R4000 Manual

B0059001 / Rev. 2.3
7.5

Setup X/Y diagnosis

1
Fig. 40: Setup X/Y diagnosis
X-share of signal:
Y- share of signal:
Pos: 54 /Sc hweis snaht/ Geräte/ SN D40/8 Bet rieb/Rundkö rpe r/Sta tis tikfunk tion @ 0\mod_1 186 4731 134 37_ 501.do cx @ 4 449 @ 2 @ 1
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Weld Seam Detection System R4000 SND40
for Tubes, Cans and Drums
2
Starts the continuous measuring
operation.
(Signals see chapter 11.1
timing diagram x/y with test job PLC or
test job KM)
Stops the continuous measuring
operation.
Changes over to the "setup operation"
mode.
yellow line.
green line.
Manual
3
Prints out the signal visualization and
the eddy current parameters.
No key function in this mode.
Selects the parameters from the list.
Changes the program parameters.
Operation
Screen area
1: Indication of the X and Y
signals and the control
signal vs. time.
2: 2-dimensional indication of
the signals of the eddy
current sensor.
3: Indication of all parameters
of the eddy current channel
and parameters for
controlling the X/Y
visualization.
73