Roland R4000 Manual page 75

B0059001 / Rev. 2.3
7.6.1 Generating Log files
The system can generate 3 different Log files:
1. Statistics.log
Generating this file can be switched on with system parameter <Statistics on/off>.
Example:
[STATISTICS]
GOOD = 148634
BAD = 552
SLIPPAGE = 168
[PROGRAM]
ACTIVE PROGRAM = 2
[ERROR]
CURRENT_POSITION = 17
ERROR1 = 0X00C
ERROR2 = 0X00C
ERROR3 = 0X00C
2. SNlog.1234
Generating this file can be switched on with system parameter <SN file on/off>
The file extension encrypts the current date (year*365 + month*31 + day). After 14 days the oldest
file will automatically be deleted. (Statement of signal-noise-ratio from SND version 1.17)
Here all messages are stored, which are shown in the status bar.
Example:
Weld seam detection good
Weld seam detection good
PM: AC overdrive
Weld seam detection not possible
...
3. Signal1.log
Shows the digital values of the measured tubes.
The file can be accessed with keys <System> <store Job>. There will be max. 10 files generated,
then the first file will be overwritten.
Example:
ProgNo 4, 14/02/07 23:53
Weld seam detection not possible 0.9dB
Original, Filter, Check
2503, 382, -83
1722, 180, -47
2424, 358, -61
1448, 127, -67
654, 26, -34
-1646, 165, -49
-1742, 185, -7
Pos: 56 /Sc hweis snaht/ Geräte/ SN D40/8 Bet rieb/Rundkö rpe r/Sys tem-Parame ter @ 0\mod_1 1864 727 391 25_5 01.do cx @ 44 43 @ 2 @ 1
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Weld Seam Detection System R4000 SND40
for Tubes, Cans and Drums
14dB 10/04/07
12dB 10/04/07
10/04/07 09:48
0.9dB
Manual
09:47
09:48
10/04/07 09:49
(inserted from SND version 1.17)
Operation
75