Table of Contents
Advertisement
B0059001 / Rev. 2.3
7
Operation
Pos: 49 /Sc hweis snaht/ Geräte/ SN D40/8 Bet rieb/Ei nsc halten und Ho chfah ren @ 0\mod_1 1872 561 173 12_5 01.do cx @ 45 53 @ 2 @ 1
7.1
Switching on and Powering up
The system will be switched on by applying mains power. The operating software will then
automatically be loaded. This procedure can require up to 30 seconds.
While the operating software becomes loaded, the system will check the voltages, cables and
sensors. If a fault condition is detected here, the system will show respective messages.
Has the operating software been loaded, the system automatically switches over to the
measurement mode and loads the last used measurement program. If another measurement
program is to be used, the operator must change over to the program list (with the <SETUP> key)
and choose a suitable program.
Pos: 50 /Sc hweis snaht/ Geräte/ SN D40/8 Bet rieb/Rundkö rpe r/Messbe trie b @ 0\mod_ 118 647 1822 281 _50 1.docx @ 443 3 @ 2 @ 1
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Weld Seam Detection System R4000 SND40
for Tubes, Cans and Drums
Manual
Operation
69
Advertisement
Table of Contents
