Table of Contents
Advertisement
Operation
7.7
System Parameters
Setting the system parameters
Fig. 42: System parameters
Pos: 57 /Sc hweis snaht/ Geräte/ SN D40/8 Bet rieb/ Ände rn von Pa rametern @ 0\mod _11 8666 431 796 8_50 1.docx @ 450 1 @ 3 @ 1
76
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Weld Seam Detection System R4000 SND40
for Tubes, Cans and Drums
Changes the current parameter
settings.
Shows the hardware parameters.
Stores the data of the last
measurements [signal1.log].
Returns to the measuring mode.
Manual
Prints out the signal progression and
al list of the eddy current parameters.
No key function in this mode.
Selects the parameters from the list.
No key function in this mode.
B0059001 / Rev. 2.3
Advertisement
Table of Contents
