Table of Contents
Advertisement
B0059001 / Rev. 2.3
Standard wiring of interface
Operational condition: Setup - Edit
Condition!
1.
The unit must be in "Setup - Edit" condition.
2.
System parameter "Test job control mode: KM" (by SND40 key)
3.
Test job or speed measurement (is started by key operation and automatically terminated).
4.
The PLC must already have the tube prepared for rotation. The PLC must then accordingly output the signal "motor"
to rotate the tube.
Parallel Data Outputs
OUT0 / Start Test job active
OUT2 / Ready for measuring
OUT6 / Reduced detecting capability
1:
< 100 ms
t2:
Duration of test procedure / speed measurement depending on tube diameter and tube rotation rate.
t3:
≥ 0 ms
t4:
> 30 ms
The duration of parameter optimization (test job / speed measurement) depends on tube diameter, tube rotation rate and
the time required for entering the parameters.
Test job:
Speed measurement
1)
Not mentioned inputs / outputs of the interface are not required for parameter programming.
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Weld Seam Detection System R4000 SND40
for Tubes, Cans and Drums
Key / Start test job
1)
OUT3 / Setup active
OUT4 / Slippage
OUT5 / General fault
OUT7 / Motor
Transient time + 3 to 4 tube turns
approx. 60 s transient time + 5 tube turns
Manual
t1
t2
Technical records
t3
t4
151
Advertisement
Table of Contents
