Table of Contents
Advertisement
Maintenance
After selecting and confirming the dialog, the copy process starts; the progress bar is displayed in
the left area of the status bar.
The program uses the following format to name the backup directory:
Year_Month_Day_Time_<Geometry>
According to the parameter "PRODGEOM" in the file "System.cfg", the suffix "Round" is used for
<Geometry> in measurement mode "Round" or "Flat" in measurement mode "Flat".
This makes it possible to back up from different dates and / or systems on a USB stick.
10.5.3.2 Function „Restore system files"
This function copies all system configuration files from the selected backup directory to the
SND40 program directory.
The process of this function is in many parts similar to the backup process. First of all, the
verification of a connected backup USB stick takes place again; If necessary, observe the
instructions in previous chapter "Function Save system and program files".
134
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Weld Seam Detection System R4000 SND40
for Tubes, Cans and Drums
Note
In order to use an own directory structure on the USB stick, this must
be already present on the USB stick; creating new folders is not
possible within this dialog.
Manual
In case the copy procedure has been
successful, a message window appears and
the numbers of copied files are displayed in the
status bar.
B0059001 / Rev. 2.3
Advertisement
Table of Contents
