Program Status / Operational Status - Roland R4000 Manual

B0059001 / Rev. 2.3
10.4

Program status / Operational status

Program status
Inactive
Automatic
Setup
Pos: 116 /Schweis snah t/Gerä te/SN D40/1 0 Wa rtun g/Bet rieb szu stände Au tomatik @ 0\mod_1 131 962 8849 06_ 501.do cx @ 9 53 @ 3 @ 1
10.4.1 Operational conditions in program status „Automatic"
Ready:
Active:
Program change:
Error:
Pos: 117 /Schweis snah t/Gerä te/SN D40/1 0 Wa rtun g/SN D40 Sto re @ 4\mod _15 5446 201 434 3_50 1.docx @ 460 99 @ 2333 444 4 @ 1
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Weld Seam Detection System R4000 SND40
for Tubes, Cans and Drums
Operational status
System start
Program invalid
Inactive
System configuration invalid
Ready
Active
Program change
Program invalid
Error
Done
Inactive
System configuration invalid
Section active
Edit
Active
Program change
Error
Program invalid
Measurement stopped
Inactive
System configuration invalid
Speed meas. finished
X/Y active
X/Y sampling done
Section active
Wait for PLC
Neither a program change nor a detecting job is active. The unit is ready for
the next job or program change via PLC. The operator can use the keys
"Print", "Statistics", "Program" or "System".
A detecting job was started by the PLC. This operational condition will be
automatically terminated, as soon as the positioning procedure has been
performed. When no error condition is existing, the condition changes over
to "Ready".
A program change was started by the PLC. This operational condition will be
automatically terminated, as soon as the change has been performed by the
PLC, also if a change was not possible since a non-existing program number
was selected. Then a message is released which will be displayed in the
"error message" field.
Note: In this case the unchanged program number will be mirrored back at
the PLC interface, since the change was not possible.
A started detecting job cannot be executed. An operator intervention is
required to redress this condition. The cause for this condition may be
internal or external disturbances which do not redress themselves. In the
field "error message" the triggering error message is shown.
Manual
Maintenance
129