As connection plug standardized shielded SUB D 9 Profibus connectors are suitable.
The use of connection plugs with integrated (switchable) terminating resistors is recommended.
If the SND40 is placed at the bus end / begin, the terminating resistor must be switched on.
Fig. 26: Profibus module cable
Fig. 27: SND40 Profibus module
The bus address can also be set in the system configuration of the SND40. To do this, the switches
on the module must be set to 00.
Pos: 36 /Sc hweis snaht/ Geräte/ SN D40/5 E lektrisc he In stal lation/P rofiNe t IO - An schl uss @ 1\mod_ 120 0483 457 781_ 501. docx @ 5 353 @ 3 @ 1
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33