Table of Contents
Advertisement
B0059001 / Rev. 2.3
11.2.4.2 Exchanging the leakage flux module
Fig. 87: Exchanging the leakage flux module
•
Loosen all cable plugs and the 4 fixing screws.
Every screw connection consists of an M3 screw, a toothed washer and a flat washer.
•
Do not lose any parts, danger of short-circuit.
Carefully pull the module at the upper and lower side, in order to loosen it from its socket.
•
•
Insert the modified leakage flux module with the same orientation into the socket.
•
If the module has been correctly inserted, the fixing holes and the holes of the support bolts
match.
•
Re-fasten the module with the screws and put-on the cable plugs again.
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Weld Seam Detection System R4000 SND40
for Tubes, Cans and Drums
Manual
Technical records
Change of components
Leakage flux
1:
module
161
Advertisement
Table of Contents
